Easy Mount™ Grab Bar, ADA Compliant, 1.25" #304 Stainless Steel

Professional installation by a qualified contractor is recommended. HealthCraft's warranty does not cover damage from improper installation or third-party services, and HealthCraft's liability is limited to the purchase price of the product.

Installation required

1. Locate studs or structural blocking. The bar may be installed vertically into one stud or at an angle between two studs.
2. Hold the bar against the wall, level it, and mark screw locations through the flanges.
3. Drill pilot holes.
4. Fasten with the supplied #10 x 2" stainless steel wood screws (6 included) using appropriate waterproofing at each fastener.
5. Slide the flange covers over the flanges to conceal the screws.
6. Check hardware regularly and tighten as needed.

Tools needed

Level, drill with pilot bit, tape measure and marker.

Read the complete manufacturer instructions supplied with the product before installation.

• Failure to follow the manufacturer's instructions could result in serious injury or death.
• Maximum user weight 500 lbs. Product is not intended to support full body weight.
• Install only to structurally sound walls. Add wood blocking if adequate structure is not present.
• Do not install if the structure behind the wall is unknown.
• Do not install into metal studs.
• Do not install where there is no structure behind drywall unless using Easy Mount™ Hollow Wall Anchors (300 lb capacity each).
• Do not install in fiberglass or acrylic shower enclosures with insufficient stiffness and strength.
• Rail and bathtub are slippery when wet.
• Do not use corrosive or abrasive cleaning products.
• Professional installation by a qualified contractor is recommended.
• HealthCraft's warranty does not cover damage from improper installation or third-party services, and HealthCraft's liability is limited to the purchase price of the product.